Hippolift Steel Fixed Height Gantry Crane

This general engineering product specification is for the Wallace Hippolift fixed-height steel square-tube gantry crane which comes in 1. 2. 3, and 5-ton models. This spec is for the 1, 2 and 3-ton models only.

General Engineering Product Specification

Gantry end frames shall be of steel square tube construction manufactured to Wallace Cranes standards including, but not limited to, the following:

  • Gantry shall be fixed in height.
  • Gantry shall be adjustable in span so that operators may adjust the crane to an inboard braced, outboard braced, or a combination of the two or approved cantilevered configuration.
  • Gantry shall have a fixed caster frame spread; and welded caster frame plates for attachment of casters.
  • I-beam shall be American Standard with a design deflection of no greater than 1/800th of the span in accordance with Wallace design criteria. I-beam shall be free-swinging and self-aligning to allow lifting off-center loads.
  • Gantry shall be equipped with four, 360 degree rotating, non-marking phenolic resin casters with 4-position swivel locks, at 90 degrees, to provide easy steering of the crane by locking “lead” casters only, or to allow positioning of the crane more firmly than a brake by locking all four casters 90 degrees to each other. Casters shall be 6” or 8” diameter as determined by capacity, height, and span of the crane.
  • The I-beam and I-beam brackets shall be painted with red gloss industrial quality paint.
  • The frames, including brace legs, caster frames, and main legs shall be dip-painted with red gloss industrial quality paint to protect both inner and outer tubing walls.
  • The model number to be provided shall be tested in accordance with Wallace specifications (A specific unit shipped is not tested; unless a Certificate of Test is ordered [additional charge applies]).
  • Gantry bolts and hardware shall be plated to prevent corrosion.
  • Gantry is manufactured in accordance with our interpretation of ANSI B30.17 and U.S. OSHA, (Section 1910.179, revised January 1976), regulations at the time of manufacture.

Downloadable / Printable PDF Version of the Specification

Download or print a PDF version of the specification.

Last Rev. 1/2016